Foreword | p. xxix |
Cisco IOS Software | p. 1 |
Benefits | p. 2 |
Packaging | p. 6 |
Features Supported | p. 7 |
Cisco Router Hardware | p. 23 |
Cisco Router Network Hierarchy | p. 24 |
Online Insertion and Removal (OIR) | p. 28 |
Cisco 12000 Series | p. 29 |
Cisco 7500 Series | p. 43 |
7200 Series | p. 49 |
7000 Series | p. 52 |
Cisco 7x00 Series Port and Service Adapters | p. 68 |
4000 Series | p. 78 |
3600 Series | p. 81 |
2600 Series | p. 91 |
1600 Series | p. 105 |
700M Family of Access Routers | p. 108 |
Cisco Router Network Design | p. 113 |
The NetworkInfrastructure Lifecycle | p. 115 |
Design Criteria | p. 118 |
Network Devices and Capabilities | p. 127 |
Selecting Routing Protocol | p. 136 |
IP Routing Protocol Design | p. 143 |
RIP, RIP2, and IGRP Network Design | p. 145 |
EIGRP Network Design | p. 148 |
OSPF Network Design | p. 152 |
Frame Relay Network Design | p. 161 |
Hierarchical Design of Frame Relay Internetworks | p. 162 |
Frame Relay Network Topology | p. 165 |
Broadcast Traffic Issues | p. 171 |
Performance Considerations | p. 171 |
SNA Support | p. 175 |
ATM Internetworking Design | p. 181 |
LAN Emulation (LANE) | p. 182 |
Data Exchange Interface (DXI) | p. 192 |
Classical IP | p. 193 |
Multiprotocol over ATM (MPOA) | p. 194 |
Bandwidth Support on Routers | p. 197 |
Configurable Traffic Parameters | p. 198 |
Switched LAN Design | p. 199 |
Switched LAN Factors | p. 200 |
Cisco VLAN Implementation Support | p. 202 |
Switched LAN Topologies | p. 210 |
SRB/RSRB Network Design | p. 215 |
Steps to Effective SRB Design | p. 216 |
Typical SRB Topologies | p. 219 |
Virtual Ring Concept | p. 224 |
Proxy Explorer | p. 229 |
NetBIOS Broadcast Control | p. 230 |
Remote SRB Encapsulation Techniques | p. 233 |
Parallel WAN Link Issues | p. 236 |
IP Routing Protocols and SRB | p. 240 |
Queuing and Prioritization | p. 242 |
DLSw+ Network Design | p. 245 |
DLSw Standard | p. 246 |
Cisco DLSw+ | p. 250 |
Cisco DLSw+ Transport | p. 256 |
Cisco's Enhanced Modes of Operation | p. 259 |
Availability Configurations | p. 261 |
Performance Features | p. 265 |
APPN Network Design | p. 269 |
Cisco Support of APPN | p. 272 |
Deciding Factors on Using APPN | p. 273 |
Dependent Logical Unit Requester/Server | p. 277 |
Network Node Placement | p. 277 |
Performance Considerations | p. 278 |
Recovery Techniques | p. 286 |
Queuing and Prioritization | p. 289 |
APPN Buffer and Memory Management | p. 289 |
ISDN and Dial-On-Demand Routing (DDR) Design | p. 293 |
Site Options | p. 294 |
Central Office Switch Considerations | p. 295 |
PRI and BRI | p. 297 |
DDR Model | p. 298 |
DDR Dialer Cloud | p. 299 |
IP Addressing | p. 300 |
Topology | p. 300 |
Dial Service Considerations | p. 302 |
Routing Packets | p. 305 |
DDR as Dial Backup | p. 309 |
Connection Triggering | p. 309 |
Security | p. 313 |
Preparing the Cisco Router | p. 315 |
Determining the Proper IOS Code | p. 316 |
Locate IOS Using Cisco Connection Online (CCO) | p. 319 |
Loading IOS on the Router | p. 321 |
Loading CIP or CPA Microcode on a Cisco 7000/7200/7500 Router | p. 328 |
Router Basic Configuration and IOS Commands | p. 333 |
IP Configuration | p. 349 |
Defining Subnets on the Router Interfaces | p. 350 |
IP Address Mapping | p. 359 |
Enabling the Use of IP Host Names in Cisco IOS Commands | p. 363 |
Disable IP Routing | p. 366 |
Bridging IP, Instead of Routing IP | p. 369 |
Controlling and Managing Broadcast Packets | p. 370 |
Configure IP Services | p. 373 |
Filter IP Packets Using Access Lists | p. 376 |
Fault-Tolerant Routing of IP Packets | p. 390 |
IP Performance Tuning | p. 396 |
Performance Enhancements Through Switching Features | p. 398 |
Defining RIP Routing Protocol | p. 405 |
The Basics of RIP | p. 406 |
Why Use RIP as the Routing Protocol? | p. 407 |
Defining RIP as a Routing Protocol on the Router | p. 408 |
Allow Point-to-Point (NBMA) Updates for RIP | p. 411 |
Specifying the Version of RIP | p. 416 |
Enabling RIP Version 2 Authentication | p. 419 |
Disable RIP Version 2 Route Summarization | p. 423 |
Disabling the Validation of Source IP Addresses | p. 426 |
Reducing Routing Loops with Split-horizon | p. 428 |
Tuning RIP Update Packet Delays | p. 428 |
RIP Updates and the Affect on Bandwidth | p. 429 |
Configuring IGRP Routing Protocol | p. 431 |
Managing IGRP Updates and Route Advertisements | p. 433 |
Defining IGRP as a Routing Process | p. 437 |
Using Unicast IGRP Routing Updates | p. 441 |
Increasing Throughput and Reliability Using Unequal-Cost Paths | p. 445 |
Altering IGRP Routing and Metric Computations | p. 447 |
Decreasing IGRP Route Convergence | p. 451 |
Tuning IGRP Route Convergence | p. 453 |
Controlling the Logical Size of an IGRP Network | p. 454 |
Validate Source IP Addresses | p. 455 |
IGRP Updates and the Affect on Bandwidth | p. 456 |
Configuring Enhanced IGRP (EIGRP) Routing Protocol | p. 459 |
Enable EIGRP as a Routing Protocol | p. 461 |
Migrating to EIGRP from IGRP | p. 465 |
Monitoring Neighbor Adjacency Changes | p. 467 |
Managing EIGRP Bandwidth Utilization | p. 469 |
Modifying EIGRP Metric Weights | p. 472 |
Routing Between Disconnected Networks with EIGRP | p. 476 |
Summarizing Routes for Advertisements out Specific Interfaces | p. 478 |
Tuning Hello Packet and the Hold Time intervals | p. 479 |
Split-Horizon and EIGRP | p. 481 |
MD5 Authentication with EIGRP | p. 482 |
Configuring OSPF Routing Protocol | p. 487 |
OSPF with Cisco IOS | p. 490 |
Specifying OSPF on Cisco Routers | p. 491 |
Multi-Area OSPF Networks | p. 500 |
Stub, Totally Stubby, and Not-So-Stubby-Area (NSSA) OSPF Areas | p. 507 |
Using OSPF Virtual Links | p. 514 |
Non-Broadcast and Broadcast Network Configurations | p. 517 |
Configuring BGP Routing Protocol | p. 525 |
Exterior and Interior BGP Sessions | p. 527 |
Path Selection Under BGP | p. 529 |
Defining the BGP Process | p. 530 |
Route Redistribution | p. 593 |
Understanding Route Redistribution | p. 594 |
Selecting the Best Path Based on a Routing Protocol | p. 598 |
Redistribution Examples | p. 606 |
Defining ATM (LANE, Classical IP, and MPOA) | p. 619 |
Configuring LANE | p. 620 |
Configure ATM over a Serial Interface | p. 638 |
Configuring Classical IP | p. 640 |
Configuring Multiprotocol over ATM (MPOA) | p. 644 |
Defining Frame Relay | p. 655 |
A Simple Frame Relay Configuration | p. 656 |
Dynamic and Static Addressing | p. 659 |
Frame Relay Subinterfaces | p. 664 |
Hub and Spoke Configurations | p. 670 |
Traffic Shaping on Frame Relay | p. 674 |
Transparent Bridging | p. 678 |
Managing Performance Problems Using the Broadcast Queue | p. 681 |
Internet-working Legacy Systems | p. 683 |
Serial Tunneling (STUN) | p. 685 |
Source-Route Bridging Configuration | p. 695 |
Data Link Switching Configuration Plus (DLSw+) | p. 704 |
SDLC to LLC2 (SDLLC) | p. 722 |
Frame Relay BNN and BAN Connectivity | p. 731 |
APPN Support on Cisco Routers | p. 741 |
SNA Support Using a Channel-Attached Cisco Router | p. 750 |
IP Connectivity Using a Channel-Attached Cisco Router | p. 761 |
Defining Novell Networks | p. 765 |
IPX Processing | p. 766 |
Routing IPX | p. 769 |
IPX Route Redistribution | p. 792 |
Bridging IPX | p. 793 |
Configuring ISDN | p. 797 |
Configuring BRI Service | p. 798 |
Configuring Primary Rate Interface (PRI) Service | p. 802 |
Dial-On-Demand routing (DDR) with ISDN | p. 805 |
Using Caller ID | p. 809 |
ISDN Callback | p. 810 |
SNAPSHOT Routing with ISDN | p. 812 |
Using ISDN for dial backup | p. 817 |
Appendix A | p. 821 |
Appendix B | p. 827 |
Appendix C | p. 831 |
Appendix D | p. 833 |
Glossary | p. 837 |
Index | p. 873 |
Table of Contents provided by Syndetics. All Rights Reserved. |